![]() Make sure you always read the instruction manual before cleaning so as not to void the warranty. ![]() It is important to do this before you put it back into storage since it will be more difficult if you leave debris to become encrusted with time. Place it on a firm work surface and remove any debris that has become lodged in the blades. You should also take care of basic trimmer maintenance before you put it back into your shed. After you finishĪfter you finish, you need to clean up the trimmings – if you have used a tarpaulin, this part will be easy. Otherwise, it is much harder to cut in a straight line. It is much better to stand still in one place and to cut everything within reach and then to move on than to trim while walking. Stand in one place and trim before moving on This will allow you to stand further back from the hedge as you trim, giving you a better view of what you are working on. If you set it at 90°, you will need to walk along the hedge directly below and won’t be able to see what you are cutting. Similarly, if you are trimming the top of a tall hedge from below, don’t set the angle at 90° – for the same reason. This will allow you to stand back from the hedge slightly, giving you a much better view of your work. Instead, set the head at a slight angle, perhaps about 25°. If the blade is too straight, you will end up standing too close to the hedge to see what you are doing. When working at waist or chest height, don’t leave the blade completely straight. Related: Check out this comparison of the GTech HT20 vs the GTech HT05. ![]() If you don’t angle the head correctly, it will limit your ability to see what you are working on.Īs another example, the cordless GTech HT20 allows the attachment of an optional branch cutter so the angle may be different again when using this. Most pole trimmers allow you to adjust the angle of the trimming head, and not using the correct angle is a mistake that many novices can make. Many trimmers have a circular grip – when trimming above your head, this is the one to use to give you greater reach. The back hand should still be on the same handle at the rear of the trimmer, but the front hand should be further back too. When cutting above your head, you will need to change your grip. This will balance the weight of the trimmer between your two hands and give you the greatest control. When using the trimmer in front of you at waist or chest height, you should place one hand on the handle at the rear of the trimmer and the other on the handle that is furthest forward. This is because since it’s longer than a regular trimmer, if you don’t hold it correctly, you will find it too heavy to wield because the balance will be wrong. With a pole trimmer, you need to have the right grip. Here are the tips you need to know to ensure you have the best technique. Once you have taken all the necessary safety precautions and have made sure the ground and the hedge are free of debris and obstacles, you are ready to start trimming. If you don’t, you will have to rake the trimmings up manually, which is much more time-consuming. If you can lay tarpaulin where you plan to trim, it will make it much easier to pick up the trimmings after. While you do this, you can also pull out any debris from the hedge that might become stuck in your trimmer and cause it to jam. Make sure there are no birds nests inside that you are going to disturbĬheck out the “ Hedge Law” to make sure you are not breaking any rules that could land you in serious trouble! This is especially important when working with a hedge trimmer since you are more likely to be looking up and not concentrating on the ground where you are placing your feet. Check the ground before you startīefore you start trimming, check the ground where you will be working for any debris that you may trip over or even rabbit holes that you might step in. You can use something like WD40, but please check the manual first because it might not be safe to use it with the type of blade you have. This will ensure your trimmer is in good working condition before you turn it on. Lubricate the blade before you startĮach time you start work, especially if you haven’t used the trimmer for some time, you should lubricate the blade.įor best results, use spray lubricating oil along the blade, both on the top and on the bottom. Finally, for the same reason, you should consider wearing a hard hat for safety. Since with a long reach hedge trimmer, you are likely to be working on hedges above head height, it is also important that you wear a proper pair of safety goggles – a pair of specs or sunglasses are not good enough.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |